Home » 27.. The list of failures and conditions under which the use of vehicles is prohibited » 1. Brake system

Brake system

Section 1Section 2

The list of failures and conditions under which the use of vehicles is prohibited

Brake system

1.1. The norms of the braking performance of the working brake system does not correspond to IS 2742.

1.2. Tightness of hydraulic brake actuator is infringed.

1.3. Violation of the tightness of pneumatic and pneumohydraulic brake actuators causes a drop of air pressure when the engine is switched off at 0.05 Mpa and more, in 15 minutes after completely putting them into effect. Leakage of compressed air from the wheel brake chamber.

1.4. Gauge of the pneumatic or pneumohydraulic brake actuators is not working.

1.5. Parking brake system does not provide immobile state of:

  • vehicles with a full load - on the slope up to 16 percent inclusive;
  • cars and buses in the loaded condition - on the slope of up to 23 percent inclusive;
  • trucks and road trains in the loaded condition - on the slope of up to 31 percent, inclusive.

 

see. - Steering